Main air filter element regeneration
Replacing dry filter locking element
Back assembly of air filter elements
Checking amount of oil in hydrostatic steering tank
- pull to remove the main dry filter element (2)
If main element is not damaged (there must not be dust on
the internal side of the element) regenerate by blowing
with compressed air from the internal side of the element.
Main element can be regenerated this way 3 times
maximum. Element must be replaced once a year.
G713
- remove dry filter locking element (3) with a pull
Lockin
element cannot be re
enerated. It must
be always replaced in these cases:
- when damaging main element
- after 5 maintenances of air filter
- at least once in two years
G714
Do back assembly of air filter elements reversely.
Mind the following with back assembly:
- contact surfaces cleanliness
- elements must not be deformed with assembly and must
not vibrate after assembly
- after closing the filter with a lid a perfect tightness of the
whole filter must be ensured
- after completing the maintenance of dry air filter, secure
proper function of pollution indicator
G715
Inspect daily before starting the operation with tractor
standing horizontally. Lift off the bonnet. Unscrew dipstick,
wipe off with a cloth and screw back in. After repeated
unscrewing of the gauge, the level must not drop below
bottom gauge line. Replenish the oil when necessary after
demounting the cap of the tank.
E719
To Next Page
Loading...
Need help?
General