Section 1 Introduction
1.1 This manual
The engineering manual contains instructions on how to engineer the IEDs using the
different tools in PCM600. The manual provides instructions on how to set up a
PCM600 project and insert IEDs to the project structure. The manual also recommends
a sequence for engineering of protection and control functions, LHMI functions as well
as communication engineering for IEC 61850 and other supported protocols.
1.2 Intended audience
This manual addresses system and project engineers involved in the engineering
process of a project, and installation and commissioning personnel, who use technical
data during engineering, installation and commissioning, and in normal service.
The system engineer must have a thorough knowledge of the load-shedding
functionality, protection and control equipment and the configured functional logic in
the IEDs. The installation and commissioning personnel must have a basic knowledge
of handling electronic equipment.
1.3 Product documentation
1.3.1 Product documentation set
The application manual contains application descriptions and setting guidelines sorted
per function. The manual can be used to find out when and for what purpose a typical
protection function can be used. The manual can also be used when calculating settings.
The communication protocol manual describes a communication protocol supported by
the IED. The manual concentrates on vendor-specific implementations.
The engineering guide provides information for IEC 61850 engineering of the
protection IEDs with PCM600 and IET600. This guide concentrates especially on the
configuration of GOOSE communication with these tools. The guide can be used as a
technical reference during the engineering phase, installation and commissioning
1MRS240044-IB A Section 1
Introduction
REF615R 5
Engineering Manual
To Next Page
Loading...
Need help?
General
