AMX MVP-9000i User Manual

Programming
157
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Intercom Commands (Cont.)
^ICM-TALK
^ICM-LISTEN
Intercom modify
command.
Intercom modify command. For backwards compatibility both versions are supported.
In this release, however, the TALK and LISTEN sub commands are ignored. The
microphone and/or speaker are activated based on the initial mode value of the intercom
start command and the audio data packet flow is started upon receipt of this command by
the panel.
Syntax:
SEND_COMMAND <DEV>,"'^ICM-TALK'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICM-TALK'"
^ICM-MICLEVEL
Intercom modify
command.
Used to set the microphone level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MICLEVEL"
Variables:
Valid levels are from 0 to 100.
Example:
SEND_COMMAND TP1, "^ICM-MICLEVEL,40"
^ICM-MUTEMIC
Intercom modify
command.
Set the state of the microphone on a panel to muted (1) or unmuted (0). At the start of
each call the microphone starts out unmuted.
Syntax:
SEND_COMMAND <DEV>, "^ICM-MUTEMIC"
Variables:
None.
Example:
SEND_COMMAND TP1, "^ICM-MUTEMIC,1"
^ICM-
SPEAKERLEVEL
Intercom modify
command.
Used to set the speaker level during an intercom call.
Syntax:
SEND_COMMAND <DEV>, "^ICM-SPEAKERLEVEL,55"
Variables:
Valid levels are from 0 to 100.
Example:
SEND_COMMAND TP1, "^ICM-SPEAKERLEVEL,55"

AMX MVP-9000i Specifications

General

Resolution	800 x 480 pixels
Connectivity	Ethernet, Wi-Fi
Display Size	9 inches
Mounting	Tabletop, Wall
Operating Temperature	32°F to 95°F (0°C to 35°C)
Operating Humidity	10% to 90% (non-condensing)

Summary

AMX Limited Warranty and Disclaimer

AMX Software License and Warranty Agreement

Configuring Communication

Wireless Network Configuration

Steps for configuring wireless network access, security settings, and master connection.

Ethernet and Virtual Master Setup

Setup Pages

Power and Battery Management

Panel Information Page

Protected Setup Pages

Protected Setup Access and Options

Accessing advanced settings and configuring system/panel options for security.

Network and Security Configuration

Configuration of network settings, security protocols, and firmware installation.

Calibration, G4 Web Control, and Passwords

SIP Settings Page

Upgrading Firmware

Firmware Upgrade Methods

Guide on upgrading firmware via USB, microSD, or NetLinx Studio.

Reverting to Factory Default Firmware

Instructions on how to reset the device to its original factory firmware and settings.

Programming

Gesture and Button Commands

Intercom and SIP Commands

Commands for intercom functionality and managing SIP phone calls.

Appendix B: Wireless Technology

Wireless Technology Overview and Terminology

Explanation of wireless standards, security, and terminology.

EAP Authentication and Configuration

Details EAP authentication, communication, firmware updates, and certificate uploads.

Configuring Firmware via USB

AMX Certificate Upload Utility

Appendix C: Troubleshooting

Common Panel and Battery Issues

Solutions for common issues like unresponsive touch, battery problems, and network detection.

Network and Download Problems