Setup Pages
50
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Testing the Battery
The Test button on the Power Management page allows you to verify that the MVP-9000i’s battery is functioning
properly and does not require reconditioning. If the battery requires reconditioning, the Test function will walk you
through the procedures necessary to start it.
To use the Test function:
1. Dock the MVP-9000i in a Table or Wall Docking Station prior to testing the battery.
2. Press the Test button.
3. If the battery does not require conditioning, a popup opens that reads "The battery is functioning normally and does
not currently need maintenance. Do you wish to run a maintenance cycle anyway?" (FIG. 56). Press No to close the
popup and return to the Power Management page, and Ye s to start the reconditioning process.
4. Pressing the Test button while the MVP-9000i is conducting its battery reconditioning process will open a popup
window reading "Battery maintenance is currently in progress. Do you wish to cancel the maintenance cycle?"
(FIG. 57). Press No to continue the battery reconditioning and close the popup window, and press Ye s to stop the
reconditioning process, close the popup window, and return to the Power Management page.
The MVP-9000i must be docked in a Table or Wall Docking Station to use the Test
function.
FIG. 56 Normal battery function popup window
FIG. 57 Battery maintenance in progress popup window
To Next Page
Loading...
Need help?
General
