Battery Life and Replacement
166
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Replacing the Battery
Before replacing the battery, download and install the latest firmware for the MVP-9000i. This firmware is available at
www.amx.com.
To remove an old battery and replace it:
1. Remove the battery from its packaging, remove the protective film from the battery, and inspect it for any damage
or distortion. If the battery shows evidence of damage, contact AMX for replacement and proper disposal
information.
2. Place the device face-down on a surface that will not scratch the unit and gently pry up the IR emitter cover. This
will usually be easier to do from the left side of the cover (FIG. 121).
3. Once the IR emitter cover is free on one side, carefully lift up away from the device to loosen and remove the IR
emitter cover.
4. Remove the two screws underneath the IR emitter cover (FIG. 122).
IMPORTANT: Prior to battery removal, run the device until the battery is completely
discharged. Do NOT discharge the battery before installing the latest MVP-9000i
firmware, available at www.amx.com.
FIG. 121 IR emitter cover removal
Screw slot
Pry up on IR emitter cover
Do NOT use tools of any sort in the screw slot, as this can damage the tab on the
back cover underneath the slot.
FIG. 122 Placement of screws underneath IR emitter cover
Screws under IR emitter cover
To Next Page
Loading...
Need help?
General
