Accessories
13
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Recharging
To recharge the MVP-9000i, slide the device into the Table Docking Station cradle bottom-first and make sure the device
is fully seated in the Docking Station. The charger pins in the bottom of the cradle (FIG. 9) must be in contact with the
connector on the bottom of the MVP-9000i for it to start recharging. The MVP panel will stop recharging automatically
once the battery has achieved its maximum charge.
Using the USB ports
The MVP-TDS-9 has two USB ports on the left of the device behind the Docking Station cradle (FIG. 9). These ports
may be used for transferring files to the MVP-9000i, as well as ports for USB-powered accessories.
Undocking the Touch Panel
For information on removing a touch panel locked into the MVP-TDS-9, please refer to the Undocking from the MVP-
TDS-9 or MVP-WDS-9 on page 22.
Cleaning the MVP-TDS-9
You should clean the MVP-TDS-9 Table Docking Station after each day’s use to maintain the device’s appearance.
Always use a clean cotton cloth and a spray bottle containing water or a non-ammonia-based cleaner, as alcohol-based
cleaners can damage the device. Do not directly spray the device: instead, spray the cloth to prevent moisture from
collecting on the charger pins. Do NOT use an abrasive of any type to clean the Table Docking Station, as this may
permanently damage or remove the device’s finish.
FIG. 9 MVP-TDS-9-GW Table Docking Station - Rear
Charger pins
Docking Station cradle
Locking groove
USB ports (2)
To Next Page
Loading...
Need help?
General
