Protected Setup Pages
69
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Open
From the Security Modes options, press the Simple button to open the Wireless Security: Simple Mode page. Scroll
through the Security Type options to select Open (FIG. 78).
Open security does not utilize any encryption methodology, but requires an SSID (alpha-numeric) entry.
This entry must match the Network Name (SSID) entry of the target AP so the panel knows what device it is using to
communicate with the network.
Refer to the Configuring Wireless Network Access section on page 29 and the Using the Wireless Site Survey Tool section
on page 30 for further details on these security options.
WEP
From the Security Modes options, press the Simple button to open the Wireless Security: Simple Mode page. Scroll
through the Security Type options to select WEP (FIG. 79).
WEP security requires that both a target AP be identified and an encryption method be implemented prior to establishing
communication. In addition to providing Open Authentication capabilities, this page also supports Hexadecimal and
ASCII keys.
FIG. 78 Wireless Security: Simple Mode - Open
Open Settings
SSID (Service Set Identifier): Opens an on-screen keyboard to enter the SSID name used on the target AP.
The SSID is a unique name used by the AP, and is assigned to all panels on
that network. An SSID is required by the AP before the panel is permitted to
join the network.
• The SSID is case sensitive and must not exceed 32 characters.
• Make sure this setting is the same for all points in your wireless network.
• If this field is left blank, the panel will attempt to connect to the first
available AP.
Cancel/Save: • Cancel - discard changes and return to the previous page.
• Save - store the new security information, apply changes, and return to the
previous page.
FIG. 79
Wireless Security: Simple Mode - WEP
To Next Page
Loading...
Need help?
General
