BMW R 1200R 2015 User Manual

prescribed minimum tread depth
is reached.
Have tires replaced even be-
fore the minimum tread depth
is reached.
Park motorcycle, ensuring that
support surface is firm and
level.
Check tire tread depth in main
tread grooves with wear indica-
tors.
Tread wear marks are
integrated into the main
grooves on every tire. If the tire
tread has worn down to the
level of the marks, the tire is
completely worn. The locations
of the marks are indicated on
the edge of the tire, e.g. by the
letters TI, TWI or by an arrow.
When the minimum tread depth
is reached:
Replace the worn tires.
Wheels
Tire recommendation
For every size of tire,
BMW Motorrad has tested and
approved certain makes as
roadworthy. BMW Motorrad
cannot evaluate the suitability of
other tires, and can therefore
take no responsibility for their
driving safety.
BMW Motorrad recommends
only using the tires tested and
approved by BMW Motorrad.
Detailed information can be
obtained from your authorized
BMW Motorrad retailer or online
at
bmw-motorrad.com
Affect of wheel sizes
on suspension control
systems
The wheel sizes play a major
role in the ABS and ASC/DTC
suspension-control systems. The
diameter and width of the wheels
stored in the control unit have
particular significance as the ba-
sis for all necessary calculations.
A change in these sizes resulting
from conversion to wheels not
installed as standard equipment
can seriously affect the control
efficiency of these systems.
The sensor reluctor rings re-
quired for wheel speed detection
must also match the control sys-
tems installed and may not be
replaced.
If you want to equip your
motorcycle with different wheels,
please contact a specialist
service facility, preferably a
BMW Motorrad retailer. In some
cases the data stored in the
8
120
z Maintenance

BMW R 1200R 2015 Specifications

General

Displacement	1170 cc
Bore x Stroke	101 mm x 73 mm
Max Power	92 kW (125 hp) at 7, 750 rpm
Max Torque	125 Nm at 6, 500 rpm
Compression Ratio	12.5:1
Fuel System	Electronic intake pipe injection
Transmission	6-speed
Final Drive	Shaft drive
Rear Brakes	Single disc brake, diameter 276 mm, double-piston floating caliper
ABS	BMW Motorrad ABS
Fuel Capacity	18 liters
Length	2, 145 mm
Wheelbase	1, 495 mm
Engine Type	Air/liquid-cooled four stroke flat twin engine, double overhead camshaft, one balance shaft
Frame	Two-section frame
Front Suspension	Telescopic fork
Rear Suspension	Cast aluminium single-sided swing arm with BMW Motorrad Paralever
Front Brakes	Twin disc brake, floating brake discs, diameter 320 mm, four-piston radial calipers
Seat Height	790 mm
Weight	231 kg
Top Speed	200 km/h