17-6
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 17 Configuring IP Unicast Layer 3 Switching on Supervisor Engine 2
Displaying Hardware Layer 3 Switching Statistics
Displaying Hardware Layer 3 Switching Statistics
Hardware Layer 3 switching statistics are obtained on a per-VLAN basis.
To display hardware Layer 3 switching statistics, perform this task:
This example shows how to display hardware Layer 3 switching statistics:
Router# show interfaces gigabitethernet 9/5 | include Switched
L2 Switched: ucast: 8199 pkt, 1362060 bytes - mcast: 6980 pkt, 371952 bytes
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
To display adjacency table information, perform this task:
This example shows how to display adjacency statistics:
Router# show adjacency gigabitethernet 9/5 detail
Protocol Interface Address
IP GigabitEthernet9/5 172.20.53.206(11)
504 packets, 6110 bytes
00605C865B82
000164F83FA50800
ARP 03:49:31
Note Adjacency statistics are updated approximately every 60 seconds.
Command Purpose
Router# show interfaces {{type
1
slot/port} |
{port-channel number}}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays hardware Layer 3 switching statistics.
Command Purpose
Router# show adjacency [{{type
1
slot/port} |
{port-channel number}} | detail | internal | summary]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays adjacency table information. The optional detail
keyword displays detailed adjacency information, including
Layer 2 information.
To Next Page
Loading...
Need help?
General
