Cisco 7609 User Manual

32-25
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 32 Configuring PFC QoS
PFC QoS Default Configuration
PFC QoS Default Configuration
Table 32-2 shows the PFC QoS default configuration.
Table 32-2 PFC QoS Default Configuration
Feature Default Value
PFC QoS global enable state Disabled
Note With PFC QoS enabled and all other PFC QoS parameters at default
values, PFC QoS sets Layer 3 DSCP to zero and Layer 2 CoS to zero in
all traffic transmitted from the router.
PFC QoS port enable state Enabled when PFC QoS is globally enabled
Port CoS value 0
Microflow policing Enabled
IntraVLAN microflow policing Disabled
Port-based or VLAN-based PFC QoS Port-based
CoS to DSCP map
(DSCP set from CoS values)
CoS 0 = DSCP 0
CoS 1 = DSCP 8
CoS 2 = DSCP 16
CoS 3 = DSCP 24
CoS 4 = DSCP 32
CoS 5 = DSCP 40
CoS 6 = DSCP 48
CoS 7 = DSCP 56
IP precedence to DSCP map
(DSCP set from IP precedence values)
IP precedence 0 = DSCP 0
IP precedence 1 = DSCP 8
IP precedence 2 = DSCP 16
IP precedence 3 = DSCP 24
IP precedence 4 = DSCP 32
IP precedence 5 = DSCP 40
IP precedence 6 = DSCP 48
IP precedence 7 = DSCP 56
DSCP to CoS map
(CoS set from DSCP values)
DSCP 0–7 = CoS 0
DSCP 8–15 = CoS 1
DSCP 16–23 = CoS 2
DSCP 24–31 = CoS 3
DSCP 32–39 = CoS 4
DSCP 40–47 = CoS 5
DSCP 48–55 = CoS 6
DSCP 56–63 = CoS 7
Marked-down DSCP from DSCP map Marked-down DSCP value equals original DSCP value (no markdown)
Policers None
Policy maps None

Cisco 7609 Specifications

General

Brand	Cisco
Model	7609
Category	Network Router
Language	English