Cisco 7609 User Manual

28-4
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 28 Configuring Traffic Storm Control
Displaying Traffic Storm Control Settings
Displaying Traffic Storm Control Settings
To display traffic storm control information, use the commands described in Table 28-1.
Note The show interfaces [{interface_type slot/port} | {port-channel number}] counters command does not
display the discard count. You must use one of the traffic-type keywords: broadcast, multicast, or
unicast, which all display the same discard count.
Table 28-1 Commands for Displaying Traffic Storm Control Status and Configuration
Command Purpose
Router# show interfaces [{type
1
slot/port} |
{port-channel number}] switchport
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays the administrative and operational status of all
Layer 2 LAN ports or the specified Layer 2 LAN port.
Router# show interfaces [{type
1
slot/port} |
{port-channel number}] counters broadcast
Router# show interfaces [{type
1
slot/port} |
{port-channel number}] counters multicast
Router# show interfaces [{type
1
slot/port} |
{port-channel number}] counters unicast
There is a single counter for all suppressed traffic. These
commands all display the same discard count, which
shows the total number of packets discarded for all three
traffic storm control modes, on all interfaces or on the
specified interface.

Cisco 7609 Specifications

General

Brand	Cisco
Model	7609
Category	Network Router
Language	English