EasyManuals Logo
Home>Cisco>Network Router>7609

Cisco 7609 User Manual

Cisco 7609
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #287 background imageLoading...
Page #287 background image
19-11
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 19 Configuring IP Unicast Layer 3 Switching on Supervisor Engine 1
Clearing IP MLS Cache Entries
This example shows how to display MLS entries for a specific source IP address:
Router# show mls ip source 172.20.52.122 any
DstIP SrcIP DstVlan-DstMAC Pkts Bytes
-----------------------------------------------------------------------
SrcDstPorts SrcDstEncap Age LastSeen
--------------------------------------
172.20.52.122 0.0.0.0 5 : 00e0.4fac.b3ff 157 6370
5 /9 ,5 /9 ARPA,ARPA 901 15:15:30
Number of Entries Found = 1
Router#
Displaying Entries for a Specific IP Flow
To display MLS cache entries for a specific IP flow (when the flow mask mode is IP-flow), perform this
task:
This example shows how to display MLS cache entries for a specific IP flow:
Router# show mls ip flow tcp detail
IP Destination IP Source Vlan Xtag L3-protocol Encapsulation RW-Vlan
--------------+---------------+----+----+-----------+-------------+-------+
RW-MACSource RW-MACDestination Bytes Packets Age Last Seen
--------------+-----------------+------------+------------+-----+---------+
QoS Police Count Threshold Leak Drop Bucket Use-Tbl Use-Enable
-----------+------------+---------+-----------+----+-------+-------+----------+
Number of Entries Found = 0
Router#
Clearing IP MLS Cache Entries
The clear mls ip command removes specific MLS cache entries. If none of the following parameters are
entered, all IP Layer 3 entries in the table are cleared:
• destination or source—Describes the IP addresses of the origin and termination point being purged.
• interface and its arguments—Limits the purge to entries for that interface.
• macd (MAC destination) or macs (MAC source)—Specifies the source or destination parameters
to use when searching for entries to purge.
• exclude protocol—Specifies all port, tcp port, or upd port and interface to allow a entries to
remain in the table.
Command Purpose
Router# show mls ip flow [tcp [any | detail |
interface type slot/port | macd
destination_mac_address | macs source_mac_address] |
udp [any | detail | interface {{vlan vlan_ID} |
{type
1
slot/port} | {port-channel number}} | macd
destination_mac_address | macs source_mac_address]]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Displays the IP MLS cache entries for a specific IP flow.

Table of Contents

Other manuals for Cisco 7609

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7609 and is the answer not in the manual?

Cisco 7609 Specifications

General IconGeneral
BrandCisco
Model7609
CategoryNetwork Router
LanguageEnglish

Related product manuals