Cisco 7609 User Manual

5-10
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 5 Configuring RPR and RPR+ Supervisor Engine Redundancy
Copying Files to the Redundant Supervisor Engine
This example shows how to perform an FSU:
Router# config terminal
Router(config)# config-register 0x2
Router(config)# boot system flash slot0: c6sup22-jsv-mz.121-11.E
Router# copy running-config start-config
Router# hw-module reset
Router# redundancy force-switchover
Router#
Copying Files to the Redundant Supervisor Engine
Use the following command to copy a file to the slot0: device on a redundant supervisor engine:
Router# copy source_device:source_filename slaveslot0:target_filename
Use the following command to copy a file to the bootflash: device on a redundant supervisor engine:
Router# copy source_device:source_filename slavesup-bootflash:target_filename
Use the following command to copy a file to the bootflash: device on a redundant MSFC:
Router# copy source_device:source_filename slavebootflash:target_filename

Cisco 7609 Specifications

General

Brand	Cisco
Model	7609
Category	Network Router
Language	English