Cisco 7609 User Manual

36-2
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
78-14064-04
Chapter 36 Configuring SNMP IfIndex Persistence
Configuring SNMP IfIndex Persistence
Note To verify that ifIndex commands have been configured, use the more system:running-config command.
Enabling and Disabling SNMP IfIndex Persistence Globally
SNMP ifIndex persistence is disabled by default. To globally enableSNMP ifIndex persistence, perform
this task:
To globally disable SNMP ifIndex persistence after enabling it, perform this task:
Enabling and Disabling SNMP IfIndex Persistence on Specific Interfaces
To enable SNMP ifIndex persistence only on a specific interface, perform this task:
Note The no snmp ifindex persistence interface command cannot be used on subinterfaces. A command
applied to an interface is automatically applied to all the subinterfaces associated with that interface.
Command Purpose
Router(config)# snmp-server ifindex persist
Globally enables SNMP ifIndex persistence.
Command Purpose
Router(config)# no snmp-server ifindex persist
Globally disables SNMP ifIndex persistence.
Command Purpose
Step 1
Router(config)# interface {vlan vlan_ID} |
{type
1
slot/port} | {port-channel
port_channel_number}
1. type = any supported interface type.
Selects an interface to configure.
Step 2
Router(config-if)# snmp ifindex persist
Enables SNMP ifIndex persistence on the specified
interface.
Router(config-if)# no snmp ifindex persist
Disables SNMP ifIndex persistence on the specified
interface.
Step 3
Router(config-if)# exit
Exits interface configuration mode.

Cisco 7609 Specifications

General

Brand	Cisco
Model	7609
Category	Network Router
Language	English