Cisco ESW 500 User Manual

Configuring Multicast Forwarding
IGMP Snooping
ESW 500 Series Switches Administration Guide 254
10
Edit IGMP Snooping Page
The
Edit IGMP Snooping Page contains the following fields:
• VLAN ID — Specifies the VLAN ID.
• IGMP Status Enable — Indicates if IGMP snooping is enabled on the VLAN. The
possible field values are:
- Enable — Enables IGMP Snooping on the VLAN.
- Disable — Disables IGMP Snooping on the VLAN.
• Auto Learn — Indicates if Auto Learn is enabled on the device. If Auto Learn is
enabled, the devices automatically learns where other Multicast groups are
located. The possible field values are:
- Enable — Enables auto learn.
- Disable — Disables auto learn.
• Host Timeout — Indicates the amount of time host waits to receive a message
before timing out. The default time is 260 seconds.
• MRouter Timeout — Indicates the amount of the time the Multicast router waits
to receive a message before it times out. The default value is 300 seconds.
• Leave Timeout — Indicates the amount of time the host waits, after requesting
to leave the IGMP group and not receiving a Join message from another station,
before timing out. If a Leave Timeout occurs, the switch notifies the Multicast
device to stop sending traffic The Leave Timeout value is either user-defined,
or an
Immediate Leave value. The default timeout is 10 seconds.
STEP 3 Define the relevant fields.

Cisco ESW 500 Specifications

General

Brand	Cisco
Model	ESW 500
Category	Switch
Language	English