Some wireless network settings may be needed to configure the adapter that has been installed in the printer. Here are
some of the settings that you may need:
Network Name, also known as SSID (Service Set ID)
BSS (Basic Service Set) Type (the type of wireless network you use—Ad-Hoc or Infrastructure)
NOTE: Infrastructure is the default wireless network type for WPS-enabled printers.
Wireless Channel Number
Network Authentication and encryption type
Security Key(s)
Wireless Encryption
WPA (Wi-Fi Protected Access) is the default security for printers with Wi-Fi Protected Setup (WPS). The following security
types are supported for WPS-enabled printers:
No security
WPA with 128-bit TKIP encryption engine
WPA2 with 128-bit AES-CCMP encryption engine
A WPA (Wi-Fi Protected Access) pre-shared key is like a password and must meet the following criteria:
If you are using Hexadecimal characters, valid keys are 64 characters long.
If you are using ASCII, valid keys are at least 8 characters long.
Installing the Dell Internal Network Adapter 1150
Installing the Dell Internal Network Adapter 1150
1. Turn off your printer, and then unplug the power cable from the wall outlet.
NOTE: To see your current network settings, print a network setup page or call your service provider or router
company for more information. For help on printing a network setup page, see
Printing a Network Setup Page.
NOTICE: Failure to unplug the printer can cause damage to your printer and adapter.
To Next Page
Loading...
Need help?
General
