Maintenance Mode
To view or change the Maintenance Mode menu settings:
1. From the main menu, use the left and right Arrow buttons to scroll to MAINTENANCE.
2. Press the Select button .
3. Use the left and right Arrow buttons until the heading you want appears on the display, and then press
the Select button .
*Factory default setting/Current setting selected by user
NOTE: The IP netmask cannot be changed if DHCP is enabled. View IP Netmask appears on the
display instead.
Set IP Gateway
Use the keypad to enter an IP Gateway. Press the Select button
to save the settings.
NOTE: The IP gateway cannot be changed if DHCP is enabled. View IP Gateway appears on the
display instead.
Main Menu Mode Main Menu
Maintenance Ink Levels
Clean Cartridges
Align Cartridges
Print Test Page
From this
menu:
You can:
Ink Levels
Press the Select button to view the level of ink in both cartridges.
Clean
Cartridges
Press the Select button
to clean the ink cartridges. A cleaning page prints. You may discard the
page when printing is complete.
Align
Cartridges
Press the Select
button to align the ink cartridges. An alignment page prints. You may discard the
page when printing is complete.
Print Test
Page
Press the Select
button to print a test page. You may discard the page when printing is complete.
To Next Page
Loading...
Need help?
General
