2-14
Chapter 2 Basic Operation
8
Turn the L-handle clockwise to fully tighten the knob screw.
Make sure that you use the L-handle to fully tighten the knob screw. If you tighten the knob
screw just by hand, the knob screw may not be tightened enough.
9
Remove the L-handle from the knob screw.
Once you change the trimming width on the PC CONTROLLER, repeat procedures described previously
to adjust the head/foot guide.
10
Close the top cover of the DKT-200.
When you do not perform offset trimming, return the adjustment dial to the “0” position.
2-2-2. Adjusting the stitching side guides and the folding side guides (option)
Fire, electrication, injury,
malfunction, or breakdown may
be caused by disassembling the
parts which are not specied in
this manual.
Do not disassemble the
product more than needs.
• Do not use the L-wrench for purposes other than instructed in this manual.
• Before following the procedures below, turn off the power switch of this machine referring
to the procedures in ”1-2. Turning off the power”
(p.2-2)
and disconnect the power cords of this
machine from the wall outlet.
If you wish to change the stitching width to other than the default, follow the procedures below
rst. When the paper is large and the stitching width is wide, it will be dicult for you to follow the
procedures.
1
Open the top cover of the DBM-600.
2
Insert the L-wrench to the fixing screw on each stitching side guide.
3
Turn the L-wrench counterclockwise to loosen the fixing screw.
Foot
Fixing screw for the side guide
Head
•
To Next Page
Loading...
Need help?
General
