7 Control / Software
Personnel:
n
Operator
n
Specialist
General information:
– The control unit / software described in this section relates exclusively
to the ‘EcoAdd
’.
– The overviews shown of the menu levels only appear in the first setting
level.
– The following screens show example displays for a pump with a
capacity of 11 l/h.
The illustrations and information shown will differ for other pump sizes!
To control and monitor the pump, it is possible to
communicate with the pump using a smartphone
having the Ecolab EcoAPP (Android operating
system from version 8 and iOS (Apple) operating
system from version 9).
However
, further explanation on these functions is
not available in this instruction.
Further information can be found in the software
description of the EcoAPP (Article no. 417102266)
see also
Ä
Chapter 1.1.2 ‘Evaluation, monitoring &
control with smartphones’ on page 10
7.1 Further safety settings
CAUTION!
When the pump is first started, NO ACCESS CODE is activated!
T
o exclude the possibility of the pump being used improperly and / or of the
system parameters being adjusted inadvertently, the pump software must
be protected by the integrated multi-stage [access code] .
During the initial configuration of the pump, we strongly recommend
enabling the [access code] and make the set passwords only available to
authorised persons:
Ä
Chapter 7.10.4 ‘Access code’ on page 97
Setting the access code also protects the pump against unauthorised
access via a smartphone connected via Bluetooth. An unprotected
pump can be accessed without restriction via the EcoAPP !
If an access code has been defined on the pump, the pump will only be
visible in the EcoAPP once the correct access code of the pump has been
entered in the EcoAPP settings.
Control / Software
63 417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
