Vital Signs Monitor User Manual Basic Operation
- 23 -
Function > Standby.
2: Automatic standby: In spot-checking or Ward round mode, if there is no measurement, alarm
and operation in process, the monitor can enter standby mode automatically without any
operations in specified time. Please enter Menu > System Setup > General > Auto Standby to
choose time from 1 min, 2 min, 5 min, 10 min, 30 min, 1 hour or Off. 30 min is default setting.
In monitor mode, permanent setting is Off.
Standby Indicator can be turned On or Off, and the indicator will light or not accordingly.
In standby mode:
1. The monitor stops monitoring and measuring. The monitoring data before entering standby
will be stored.
2. The monitor won’t respond to any alarms and prompts, except Battery Low alarm.
3. Audio alarm paused status discontinues. Audio alarm off, alarm off, alarm reset and alarm
latch status are not influenced.
4. Stop the recording work in progress.
5. Disconnected with MFM-CMS. MFM-CMS won’t update monitoring data, and will display
monitor's Offline status. When the monitor exits standby, it will reconnect with MFM-CMS.
The monitor exits standby mode in any of the conditions:
1. The user clicks anywhere on the screen or presses any key.
2. Battery Low alarm occurs.
3. MFM-CMS sends exit order to monitor.
After exiting standby mode, the monitor resumes monitoring, including parameter monitoring,
storage and alarm; users need to press Record key to restart recording.
NOTE:
The monitor is unable to enter into standby mode when exporting data.
3.4.3 Night Mode
To switch to night mode, you may:
Select the shortcut key on the main screen, or
Select Menu > Common Function > Night Mode.
NOTE:
In night mode, the sound of key and pulse is muted; the alarm volume and screen
brightness are down to their minimum; the settings including key volume, PR volume,
alarm volume and screen brightness are unavailable.
To Next Page
Loading...
Need help?
General
