Vital Signs Monitor User Manual Alarms
- 54 -
4 Prior to monitoring, make sure that the limit settings are appropriate for your patient.
5 Setting limits to extreme values may cause the alert system to become ineffective. It
is recommended to use the default settings.
8.9 Nurse Call
The monitor provides dedicated nurse call port which is connected to nurse call system through
the nurse call cable to perform the nurse call function. Enter Menu > User Maintain >
Common > Nurse Call to choose Off (default), High, Medium, Low, High+Med. or All. When
the corresponding level of physiological alarm occurs, the nurse call signal will be sent to remind
the nurse.
Nurse call and OTG are mutual excluded. That means, when nurse call is set to Off, the OTC
function is On.
NOTE:
Before using the function of nurse call, check if it is functioning normally.
To Next Page
Loading...
Need help?
General
