Vital Signs Monitor User Manual Basic Operation
- 24 -
3.5 Changing Monitor Settings
3.5.1 Adjusting Screen Brightness
To change the screen brightness, select Menu > System Setup > General, and select the
appropriate setting for the screen brightness. 10 is the brightest, 1 is the least bright.
3.5.2 Adjusting Volume
3.5.2.1 Adjusting Key Volume
The key volume is the volume you hear when you select any field on the monitor screen or when
you turn the knob.
To adjust the key volume, select Menu > System Setup > General, then select the appropriate
setting for the key volume: six levels represent volume and level five represents the maximum,
and level zero represents volume off. Default is volume off.
3.5.2.2 Adjusting Alarm Volume
To change the alarm volume, select Menu > System Setup > General and select the desired
setting for the AlarmVolume item: five levels represent volume and level five represents the
maximum, and level one represents minimum. Alarm volume cannot be off.
3.5.2.3 Adjusting Alert Volume
In monitoring or spot mode, to change the alert volume, select Menu > System Setup > General
and select the desired setting for the Alert Volume item: six levels represent volume and level
five represents the maximum, and level zero represents volume off.
3.6 Checking Your Monitor Information
To check the monitor information, please select Menu > Common Function > Device
Information. Monitor information includes Config, About, Network.
Config includes: the configuration monitor supported (such as Wi-Fi, Wired, USB, Barcode, etc.),
the currently used configurations are marked with √.
About includes: software version, serial number, device name and so on.
Network includes: Network type, Local Net No., Server IP (such as MFM-CMS), Local Mask
No., Local Gateway No., Mac address, Communication protocol and so on.
NOTE:
The contents related with network can be set in User Maintain > Network.
3.7 Device Settings
Select Menu > User Maintain, then type the correct password into the displayed interface.
Device settings include: Department, Device name, Language, Chinese Input (when it is on, the
virtual keyboard of the monitor can be switched to Chinese input method), Format Internal
To Next Page
Loading...
Need help?
General
