Vital Signs Monitor User Manual Monitor Mode
- 26 -
Chapter 4 Monitor Mode
Monitor mode is used for single patient’s monitoring and management.
4.1 Admitting a Patient
The monitor displays physiological data and stores it in the trends as soon as a patient is
connected. This allows you to monitor a patient who is not yet admitted. It is however important
to admit patients properly so that you can identify your patient on recordings, reports, and
networked devices.
During admission you enter data that the monitor needs for safe and accurate operation. For
example, the patient category setting determines the algorithm the monitor uses to process and
calculate some measurements, the safety limits that are applied for some measurements, and the
alarm limit ranges.
To admit a patient, please:
1. Select Menu > Patient Management > New Patient, or press the Admit/Create new patient
hardkey on the front panel, then a message is displayed to ask the user to confirm to
update patient.
2. Click on No to cancel this operation; click on Yes, the Patient Info window is displayed.
3. Enter the patient information:
MRN: Enter the patient’s medical record number.
Last Name: Enter the patient’s last name (family name).
First Name: Enter the patient’s first name.
Bed No.: supports up to 8 numbers. Chinese, English, number and special characters
can be input.
Doctor: Enter the attending doctor for the patient.
Gender: Male, Female and N/A.
Type: Choose the patient type, either Adult, Pediat, or Neonat.
BloodType: N/A, A, B, AB and O.
Date of Birth: Enter the patient’s date of birth.
Date of Admission: Enter the patient’s date of admission.
Height: Enter the patient’s height.
Weight: Enter the patient’s weight.
Height unit: cm or inch.
Weight unit: kg or lb.
To Next Page
Loading...
Need help?
General
