Epson SC-F10000 Series User Manual

O
Close the front cover, and then move the left and
right lock levers inward.
P
Lower the media loading lever.
When the Remaining
Media Runs Out
When the remaining media runs out during printing, a
message is displayed on the display screen of the control
panel. Follow the on-screen instructions and continue
printing by replacing the media using the following
procedure.
A
Raise the media loading lever.
B
Move to the back side and check the condition of
the media.
If the media is affixed to the roll core, then cut it
apart using scissors as seen in the illustration, and
move on to the next procedure.
If it is not affixed, then move on to the next
procedure straight away.
C
Follow the Steps 6 to 14 on "Removing the
Loaded Media" to remove the roll core.
U “Removing the Loaded Media” on page 87
D
Move to the front side, and turn Off the Auto
switch of the Auto Take-up Reel Unit.
E
Take up the media completely by operating the
Manual switch as necessary.
F
Follow the procedure on "Removing Media" to
remove the roll.
U “Removing Media” on page 86
SC-F10000 Series User's Guide
Basic Operations
89

Epson SC-F10000 Series Specifications

General

Brand	Epson
Model	SC-F10000 Series
Category	Printer
Language	English