Messages What to do
Auto Take-up Reel Unit stopped. Media is not correctly attached to the Auto Take-up Reel Unit.
Press the W button and select Job Cancel to cancel printing.
Flip the Auto switch on the Auto Take-up Reel Unit to the Off position, then flip
it back and reattach the media to the Auto Take-up Reel Unit.
U “Take-up with the Printed Side Facing Out” on page 35
U “Take-up with the Printed Side Facing In” on page 37
Media Size Error
Load correct size media.
The media currently loaded is not the correct width. Raise the media loading
lever and remove the media.
The narrowest width supported by the printer is 300 mm. Be sure the media is
at least 300 mm wide.
If this message is displayed even though the media is the correct width, the
printer may print if OFF is selected for Media Size Check.
U “The Printer Setup Menu” on page 98
Media Sensor Error
Loaded media or sensor has a problem.
Refer to manual for error details.
Media Sensor Error
Refer to manual for details of error.
Adjust manually?
Press the W button to clear the message from the display.
The auto menu of Auto Media Adjust, Auto Nozzle Check, and Media Adjust
from Easy Media Setup are not available for the following media settings or
conditions.
❏ Transparent or colored media
❏ Media with an uneven surface
❏ Media that bleeds-through easily
❏ Platen Gap is set to 2.5 in the media settings.
❏ The printer is used in a place that is exposed to direct sunlight or
interference from other ambient light sources.
In these cases, execute the manual menu.
When executing Auto Media Adjust or Media Adjust: U “Media Adjust” on
page 47
When executing Auto Nozzle Check: U “Printing nozzle check patterns” on
page 77
If the printer is exposed to interference from ambient light sources, shade the
printer from these sources and perform the function again; it may succeed.
When the function has failed after shading the printer, execute the manual menu.
If none of the above applies to you when you are performing auto menu
operations in Easy Media Setup or Media Adjust, see Troubleshooting & Tips
(Online Manual).
Roll Type Error
Release and then reset the media loading
lever, then match Roll Type setting to
actual media.
❏ Does the Roll Type specified at media loading match the actual roll type?
Raise the media loading lever to resolve the error. Lower the media
loading lever again, and follow the on-screen instructions of the printer to
correctly specify the Roll Type.
Press # and perform Head Maintenance. This message is displayed when regular cleaning has not been performed for
more than one month. If you continue to use the printer without performing
regular cleaning, ink drops, nozzle clogging, or print head damage may occur
in the printer.
U “Performing Regular Cleaning” on page 60
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Problem Solver
106
To Next Page
Loading...
Need help?
General