C
Open the front cover.
D
Soak a soft cloth in water, wring it out
thoroughly, and then wipe off any ink, lint, or
dust that has adhered to the platen heater.
Carefully remove lint and dust stuck in the
groove of the platen.
E
Soak a soft cloth in water, wring it out
thoroughly, and then wipe off any lint, or dust
that has adhered to the media edge plates.
c
Important:
When media with glue has been used, wipe
away glue using a diluted neutral detergent.
If you continue printing while glue is stuck to
the rear, it may rub against the print head.
When using media with glue and when ink
adheres
Remove the media edge plates from the printer,
and clean the front and back of the plates.
When stains are removed, be sure to attach the
plates to their original positions.
Removing and attaching the media edge plates
U “Replacing the media edge plates” on
page 73
Performing Regular
Cleaning
Clean the parts in the following order.
Moving the Print Head
Cleaning Around the Print Head
Cleaning Around the Caps
c
Important:
The following message is displayed on the control
panel display if cleaning has not been performed
for one month. When the message is displayed,
perform regular cleaning as soon as possible.
Press # and perform Head Maintenance.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Maintenance
60
To Next Page
Loading...
Need help?
General