Epson SC-S60600 Series User Manual

Problem Solver
When a Message is Displayed
If one of the following messages is displayed, read and follow the instructions below.
Messages What to do
Prepare empty waste ink bottle. The Waste Ink Bottle is getting full. Ready a new Waste Ink Bottle.
U “Options and Consumable Products” on page 113
Ink Cartridge Error
Ink cartridge cannot be recognized. Insert
again or replace ink cartridge.
❏ Remove and reinsert the ink cartridge. If the message persists, insert a new
ink cartridge (do not reinsert the ink cartridge that caused the error).
❏ Condensation may have formed inside the cartridge. Leave it at room
temperature for at least four hours before installing the cleaning cartridge.
U “Notes on handling ink cartridges” on page 19
Ink Cartridge Error
Ink cartridge cannot be detected. Insert
again or replace ink cartridge.
Ink Cartridge Error
Replace cleaning cartridge.
❏ Remove and reinsert the Cleaning Cartridge. If the message persists, insert
a new Cleaning Cartridge (do not reinsert the Cleaning Cartridge that
caused the error).
U “Replacement procedure” on page 67
❏ Condensation may have formed inside the cartridge. Leave it at room
temperature for at least four hours before installing the cleaning cartridge.
Ink Low The ink is low. Ready a new ink cartridge.
U “Options and Consumable Products” on page 113
Warming Up...
ZForce to start printing
One or more heaters is still being warmed to the specified temperature. To start
printing without waiting for the heater to warm up, press the Z button.
Command Error
Check print settings on RIP.
Press the W button and select Job Cancel. Check that the installed software
RIP is compatible with the printer.
Clogged nozzles detected.
Cleaning recommended.
Stop printing and perform head cleaning if you judge it necessary on
inspecting the print results.
U “Head Cleaning” on page 77
F/W Install Error
Firmware update failed.
Restart the printer.
Turn the printer off, wait for a few minutes, and then turn on the printer again.
Use Epson Control Dashboard to update the firmware again.
If this message appears in the control panel again, contact your dealer or Epson
Support.
Print head is nearing end of service life. The current print head is nearing the end of its service life.
Contact your dealer or Epson Support.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Problem Solver
105

Epson SC-S60600 Series Specifications

General

Brand	Epson
Model	SC-S60600 Series
Category	Printer
Language	English