Epson SC-S60600 Series User Manual

U “Saving New Media Settings” on page 45
B
Use the d/u buttons to select the roll type that
matches the loaded roll, and then press the Z
button.
OK Done
Printable Side Out
Printable Side In
Roll Type
Back
C
The screen where you can enter the length of
the loaded media is displayed.
Use the d/u buttons to choose a length
between 1.0 and 100.0 m and press the Z
button.
OK Done
Range: O,1.0 - 100.0 m
Current: 30.0 m
Length
OFF
30.0 m
Set the value when remaining amount of media
is printed on the roll.
Press the r button if you want to select OFF.
When you select OFF, the remaining amount is
not calculated.
Note:
Two functions are enabled in Remaining
Setup - ON
The following two functions give you a rough idea
of the amount of media available before printing,
making it easier to know when media requires
replacement.
❏ Showing Amount of Media Remaining
The control panel display shows the
approximate amount of media remaining
based on the length set for the media and the
amount used during printing.
❏ Remaining Alert
A warning is displayed when the amount of
media remaining reaches a specified level.
The printer will display Ready after a brief pause,
showing that it is ready to print. Transmit the data to
be printed from the computer.
Removing the Take-up
Roll
Follow the steps below when replacing the media.
1. Print the remaining amount of media. (When
Media Remaining is set to ON)
2. Cut the media.
3. Remove the media.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Basic Operations
41

Epson SC-S60600 Series Specifications

General

Brand	Epson
Model	SC-S60600 Series
Category	Printer
Language	English