Then, follow the on-screen instructions to replace the
cartridge.
Observe the following cautions when storing the ink
cartridges that were removed during use.
U “Notes on handling ink cartridges” on page 19
Cleaning inside the front
cover
Ink mist causes the inside of the front cover to become
dirty. If you continue to use the printer while this is
dirty, you cannot see inside the printer.
If it is dirty, follow the steps below to clean.
A
Make sure the printer is turned off and the
screen has turned off, and then unplug the
power cable from the outlet.
Disconnect both of the power cables.
If the additional print drying system is
installed, make sure you unplug the power
cable for the additional print drying system as
well.
B
Leave the printer for a minute.
C
Open the front cover.
D
Wipe lint and dust adhered to the inside of the
front cover using a soft cloth that has been
soaked in water and squeezed well.
For anything that cannot be removed with a
damp cloth, dip a cloth in neutral detergent,
squeeze it out, and then wipe the stubborn stain.
Cleaning pressure rollers
If you keep using the pressure rollers when they are
soiled with ink mist, the print outs will be soiled.
If the rollers are dirty, follow the steps below to clean
them.
A
Make sure the printer is turned off and the
screen has turned off, and then unplug the
power cable from the outlet.
Disconnect both of the power cables.
If the additional print drying system is
installed, make sure you unplug the power
cable for the additional print drying system as
well.
B
Leave the printer for a minute.
C
Open the front cover.
D
Raise the media loading lever.
E
Wrap a soft cloth that has been soaked in water
and squeezed well around the tip of your finger
as shown in the illustration.
F
Use the cloth to wipe the sides of the pressure
rollers that have become soiled.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Maintenance
82
To Next Page
Loading...
Need help?
General