Supported Media
The following media can be used with the printer.
Print quality is greatly affected by the type and quality
of media used. Choose a media suited to the task at
hand. For information on use, refer to the
documentation supplied with the media or contact the
manufacturer. Before buying media in large
quantities, try printing on a smaller sample and check
the results.
c
Important:
Do not use media that is wrinkled, scuffed, torn,
or dirty.
Roll media
Roll core size 2 or 3 inch
Roll outer diameter Media Feeding Unit: Up to 250 mm
Auto Take-up Reel Unit: Up to 200
mm
Media width 300 to 1626 mm (64 inch)
Media thickness Up to 1 mm
Roll weight Up to 45 kg
Cut media
Media width 300 to 1626 mm (64 inch)
Media length 500 mm or more
Media thickness Up to 1 mm
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved
to another location on the same floor without
traversing stairs, ramps, or lifts. See below for
information on moving the printer between floors or
to another building.
U “Transport” on page 118
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to
observe this precaution could result in the printer
falling over, causing accidents.
c
Important:
Do not remove the ink cartridges. Failure to
observe this precaution could cause the print head
nozzles to dry out.
Getting Ready
A
Confirm that the printer is off.
B
Remove the Waste Ink Bottle.
U “Replacing the Waste Ink Bottle” on
page 69
C
Disconnect the power cords and all other cables.
D
Remove media from the Media Feeding Unit
and Auto Take-up Reel Unit.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Appendix
117
To Next Page
Loading...
Need help?
General