❏ Ink cartridges installed in the printer (except for
WH and MS) must be removed and thoroughly
shaken once every three weeks.
WH and MS ink cartridges must be removed and
thoroughly shaken every day before starting work.
You do not need to shake the Cleaning Cartridge.
Shaking ink cartridges U “Shaking” on
page 66
Handling Media
Note the following when handling or storing media.
Media that are in poor condition will not produce
good quality prints.
Be sure to read the documentation provided with each
type of media.
Notes on Handling
❏ Do not fold the media or damage the printable
surface.
❏ Do not touch the printable surface. Moisture and
oils from your hands can affect print quality.
❏ When handling media, hold it by both edges. We
recommend wearing cotton gloves.
❏ Keep the media dry.
❏ Packaging materials can be used to store media
and should not be thrown away.
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
❏ When not in use, media should be removed from
the printer, rewound, and inserted in its original
packaging for storage. Leaving media in the
printer for extended periods may cause it to
deteriorate.
Handling Media After Printing
To maintain long lasting, high quality print results,
note the following points.
❏ Do not rub or scratch the printed surface. If they
are rubbed or scratched, the ink may peel off.
❏ Do not touch the printed surface, as this may
remove the ink.
❏ Make sure printouts are completely dry before
folding or stacking, otherwise discoloration or
other marks may appear where the prints touch.
These marks will disappear if the prints are
immediately separated and dried but will become
permanent if the surfaces are not separated.
❏ Avoid direct sunlight.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Introduction
20
To Next Page
Loading...
Need help?
General