Epson SC-S60600 Series User Manual

C
Align the roll core holder with the right edge of
the media, and tighten the screw.
D
Insert the roll core onto the right holder.
E
Push the holder until part A shown in the
illustration below is fully inserted, and tighten
the screw.
c
Important:
Stop when part A is no longer visible. The
take-up reel unit may not function as
expected if the holder is inserted too far.
F
Leave a 10 to 20 cm wide section in the center
of the media, and cut at least 25 cm in height
from the left and right corners of the media.
Cutting the media prevents feeding problems,
such as the left and right corners of media
being folded and caught at the start of take-up.
For the subsequent steps, see the following depending
on how the media is rolled.
For information on taking-up with printed side out,
see U “Take-up with the Printed Side Facing Out”
on page 35.
For information on taking-up with printed side in, see
U “Take-up with the Printed Side Facing In” on
page 37.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Basic Operations
34

Epson SC-S60600 Series Specifications

General

Brand	Epson
Model	SC-S60600 Series
Category	Printer
Language	English