E Roll core holder
Place the roll core for media take-up on these holders. There are same parts on both the left and the right.
U “Using the Auto Take-up Reel Unit” on page 32
F Roll support
Rest media temporarily on these supports when removing the take-up roll. There are same parts on both the
left and the right.
G Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
H Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is
in the Off position.
I Ink cartridges
The SC-S40600 Series only has cartridge slots on the right.
Install all ink cartridges into each slot. Depending on the maintenance operation being performed, follow the
instructions on the control panel screen to install the Cleaning Cartridge.
J Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place
after insertion.
K Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the contents of the error on the control panel's screen.
Off : No error.
L Maintenance cover (right)
Open this cover to clean the area around the caps. Normally closed when using the printer.
U “Cleaning Around the Caps” on page 63
M Media loading lever
After loading media, lower the media loading lever to keep the media in place. Raise the lever to release the
media prior to removal.
N Alert lamp
This lamp lights or flashes when an error occurs.
Light/Flash : An error occurred. The type of error is indicated by how the lamp lights or flashes. Check the
contents of the error on the control panel's screen.
Off : No error.
O Control panel
U “Control panel” on page 12
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Introduction
6
To Next Page
Loading...
Need help?
General