FEASA LED ANALYSER
ICT VERSION
setcalibration# - Select the user cal setting.............................................................................104
ResetUserCal - Reset the usercal setting to factory default....................................................105
SetCalibrationDateddmmyyyy - Set the user Cal Date...........................................................106
getcalibrationdate Get the Calibration Date set by the user....................................................107
External Capture Mode.....................................................................................................................108
Sequence Capture Mode:..................................................................................................................110
Introduction.............................................................................................................................110
Set/Put SequenceMode# - Set sequence mode for Fibers.......................................................111
Set/Put SequenceChannel@@ - Select sequence mode Fiber No..........................................112
Set/Put SequenceCapture##(#) - Set Sequence Capture Time................................................113
Set/Put SequenceWait##(#) - Set Sequence Wait Time..........................................................114
Set/Put SequenceNumber###(#) - Set the Number of Captures.............................................115
Set/Put SequenceThreshold##### - Set the Intensity Threshold............................................116
Set/Put SequenceStartDelay### - Set delay in ms before sequencecapture starts..................117
CaptureSequence - Start the Captures.....................................................................................118
StoreSequence## - Store the sequence pattern........................................................................119
IdentifySequence - Identify the current sequence pattern.......................................................120
ResetSequence## - Reset a sequence pattern..........................................................................121
ResetSequenceAll - Reset all sequence patterns.....................................................................122
GetSequenceStored## - Get a sequence pattern......................................................................123
GetSequence@@ - Get the binary sequence of Intensities.....................................................124
GetSequenceTimes@@ - Get the Duty Cycle of the Sequence..............................................125
GetSequenceTimesAll - Get the Duty Cycle of the Sequence for all fibers...........................126
GetFrequency## - Returns the frequency and duty cycle of Led............................................127
GetMax(Min)Intensity## - Returns the Max or Min Intensity for the Seq Cap.....................128
GetFlicker## - Returns the Flicker Index and frequency after a Seq Cap..............................129
GetSequenceMode# - Get sequence mode for Fibers.............................................................130
GetSequenceChannel## - Select sequence mode Fiber No....................................................131
GetSequenceCapture - Get Sequence Capture Time...............................................................132
GetSequenceWait - Get Sequence Wait Time.........................................................................133
GetSequenceNumber - Get the Number of Captures..............................................................134
GetSequenceThreshold - Get the Intensity Threshold............................................................135
GetSequenceStartDelay - Get the delay before the CS command..........................................136
Capture Sequence Sync Serial Commands.............................................................................137
Step-by-Step approach to Testing a LED.........................................................................................138
Effect of PWM on Intensity Testing.................................................................................................139
Step-by-Step approach to Testing a PWM LED...............................................................................140
Testing a 7-Segment Display............................................................................................................141
Command Summary:........................................................................................................................142
Specifications...................................................................................................................................144
Warranty...........................................................................................................................................145
5