FEASA LED ANALYSER
ICT VERSION
Set Data Mode
set/putLIN - Change the Intensity response of the Analyser
to Linear Mode
Transmit Receive
setlin
putlin
OK
OK
Description
This command will change the Intensity Response of the Analyser to measure in Linear mode.
All Analysers shipped from the factory are set in Log mode.
Please refer to the Intensity Section of this document page 8 Intensity
The set command is stored permanently in memory and can only be changed by using the
setlin command again, power on/off will NOT effect the setlin
The put values are stored in RAM memory and must be changed by using the putlin command
each time after Power On/Off.
Example:
setlin
OK
Example:
putlin
OK
Back to Index
88
To Next Page
Loading...
Need help?
General
