Setup
5
Note
The SD Card Error warning is only available on cameras that support SD / microSD cards. Check the
technical specifications for your camera.
To configure SD Card Errors:
1. Check Enable to enable SD Card Errors.
2. Check Relay-out to trigger an alarm out device when SD Card Errors occur. Under
Alarm Delay, enter the number of seconds before the alarm out device will be
activated.
Note
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
3. Check Send Email to send an email alert when SD Card Errors occur.
4. Click Save to save changes.
5.4.7 Disconnection
A Disconnection error occurs if the camera is disconnected from the network.
To configure Disconnection Errors:
1. Check Enable to enable Disconnection errors.
2. Check Record to record to the microSD / SD card when Disconnection errors occur.
Note
The camera must support microSD / SD card recording to use this function. Check the technical
specifications for your camera.
3. Under Record Delay, enter the number of seconds the camera will record after a Dis-
connection error.
#LX400038; r. 1.0/18537/18537; en-US
40
To Next Page
Loading...
Need help?
General
