Copy Service Settings
165
Tools
5
Bates Stamp - Top Left, - Top Center, - Top Right, - Bottom Left, - Bottom Center, and -
Bottom Right
You can adjust the position to print a bates stamp finely.
Quantity Display
You can select how you want to display the counter in the Copy service.
Select from [Quantity], [Quantity and Memory], and [Quantity and Original Count].
Maximum Number of Sets
Set the maximum number of allowed sets to copy between 1 and 999. Users will not be able
to specify a larger number of sets to copy than the value set here.
Original Size Defaults
Set the original sizes displayed in [Original Size] in the [Layout Adjustment] screen.
You can assign original sizes to the buttons other than [Auto Detect].
If you frequently make copies of non-standard size document, setting non-standard size as
the default can avoid extra operations required during the use of the machine.
îš„ A/B Series Size
You can select a size from A and B series sizes.
îš„ Inch Size
You can select a size from inch series sizes.
îš„ Others
You can select a size from other sizes.
îš„ Custom Size
You can enter any size. Set the width (X) from 15 to 356 mm, and the height (Y) from 15 to
216 mm in 1 mm increments.
Reduce/Enlarge Presets
Set the magnifications displayed as [Preset %] which are displayed when [Proportional %]
is selected under [Reduce/Enlarge] in the [Copy] screen.
You can assign any magnification to the Reduce/Enlarge Preset buttons other than [100%]
and [Auto %].
Custom Colors
Set the custom colors used for [Single Color] and [Dual Color] in the [Output Color] screen.
You can assign custom colors with yellow (0 to 100%), magenta (0 to 100%), and cyan (0
to 100%) to each custom color buttons 1 to 6.
Note • Adjust so that the total of yellow, magenta, and cyan does not exceed 240%.
To Next Page
Loading...
Need help?
General
