200
8.10 Intelligent multifeed setting
8.10 Intelligent multifeed setting
If photograph or something is pasted on the document and its size and/or position are same, you can easily
let the scanner memorize its size and/or position just scanning those document. To use this function, you
need to specify [Check overlapping] at [Multifeed detection] by the procedure in Section 3.7 or 8.4 in
advance.
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 177.
2. Select [Device Setting 2] from left side list in the window, and select
[Intelligent Multifeed Function] from its lower lebel.
3. Select one of the following option and press [OK]. Refer to Section 3.11
for subsequent proceduers.
4. Specify whether or not to remember the multifeed pattern at power-off
under [Remember multifeed pattern at power-off].
Selecting [Remember] allows you to use the last-remembered multifeed pattern before power-
off. (Eight patterns can be memorized at power-off.)
Manual mode: Scanner detects multifeed and stops document feeding. User can specify whether
to bypass the multifeed or not, and starts scanning by pressing [Scan] button.
Auto mode 1: Scanner detects multifeed and stops document feeding. The length and position
of the sticked paper is memorized by restarting the scanning. Multifeed is
bypassed, if the same-length paper is sticked at the same position on the docu-
ment.
Auto mode 2: Scanner detects multifeed and stops document feeding. The length of the sticked
paper is memorized by restarting the scanning. Multifeed is bypassed, if the
sticked paper is same or smaller than memorized length.
To Next Page
Loading...
Need help?
General