66
2.15 Resuming from Power Saving Mode
2.15 Resuming from Power Saving Mode
Power saving mode saves the power consumption of the scanner while the power is turned on. When the
scanner is left without operation for 15 minutes or more (factory initial setting), it automatically enters the
power saving mode.
When the scanner entered the power saving state, the LCD indication of Operation panel becomes off and
the green LED lamps for Power button and Paper Thickness keeps lighting.
If you want to resume the scanner from the power saving mode, take any of these actions below.
•Set documents on the hopper.
•Press any button on the Operator panel (except the Power button*).
* If you press the power button for two seconds or longer, the power is turned off.
•Execute any command from the scanner driver screen in the PC.
The waiting time for entering the power saving mode can be set in a range
from 15 to 55 minutes in steps of 5 minutes. To set the power saving mode,
refer to “8.2 Power saving setting” on page 185.
To Next Page
Loading...
Need help?
General