211
8.21 Auto Color Detection
8
SCANNER SETTINGS
8.21 Auto Color Detection
You can adjust the slice level for auto color detection.
Configure the settings for the Auto Color Detection as follows:
1. Start up the Software Operation Panel.
Refer to “8.1 Scanner Settings” on page 177.
2. Select [Device Setting 2] from left side list in the window, and select [Auto
color Detection] from its lower level.
3. Select the Slice value.
You can select the Slice value from 1 to 255 (255 levels).
In the case that black and white documents are judged as color documents, select larger values.
In the case that color documents are judged as black and white, select smaller values.
The auto color detection setting can be configured on the scanner driver
setting window.
For details on how to set the setting, refer to “3.11 Color/monochrome Auto
Detection” on page 96.
To Next Page
Loading...
Need help?
General