Fujitsu fi-5900C User Manual

30
2.10 Scanning Documents
2.10 Scanning Documents
When scanning documents, normally you need to run the scanner driver using the application software.
The following shows the procedure for scanning documents using the “ScandAll 21" application (simply
called “ScandAll 21" from now on.)
The procedure differs depending on application being used. When you use an application other than Scan-
dAll 21, refer to the manual attached to the application.
1. Load the documents on the hopper.
Refer to the section “2.6 Loading Documents on the Hopper” on page 17.
2. Adjust the stacker table to the document size.
3. Start up ScandAll 21.
From the [Start] menu, select [Program] - [Scanner Utility for Microsoft Windows] - [ScandAll
21]. This starts up ScandAll 21.
4. Select the scanner to use.
Select [Select Source] from the [Scan] menu.
The [Select source] dialog box appears.
Select [FUJITSU Fi-5900Cd].
Then click [Select].
ATTENTION
• When loading long documents on the hopper, extend the stacker exten-
sion.
• When loading short documents on the hopper, adjust the stacker length
with the small stopper.

Fujitsu fi-5900C Specifications

General

Brand	Fujitsu
Model	fi-5900C
Category	Scanner
Language	English