Servicing the PM880 8-11
August 2003
Resetting to Factory Default Parameters
For various reasons, you might wish to return the PM880 to its
original settings. The Factory Defaults option enables you to
return the meter to its preprogrammed default settings. To enter
the option, scroll down to the Factory Defaults entry in the
Service Menu and press
[ENTER]. The screen will appear similar
to Figure 8-10 below.
Note: All sites and logs will be lost if you use the Factory
Defaults option. Be sure to transfer or print all sites and
logs before resetting!
Figure 8-10: The Factory Defaults Option
1. To restore Factory Default settings:
• Press [F2] (Cancel) to return to Operate Mode without
changing the current settings.
• Press [F3] (OK) to confirm that you wish to restore the
factory default settings.
2. The program asks for confirmation: “Are you SURE?” Repeat
the procedure shown in Step 1 above.
The PM880 replaces the default site file and the global meter
settings with the factory default settings, and returns to Operate
Mode.
Factory Defaults
Cancel OK
*** WARNING ***
You will LOSE all changes by
pressing OK.
Choose CANCEL to exit or OK to
proceed.
To Next Page
Loading...
Need help?
General
