Servicing the PM880 8-13
August 2003
Updating Software Via IrOBEX
To begin updating software via IrOBEX, scroll down to the Flash
Update entry in the Service Menu and press
[ENTER]. The screen
appears similar to Figure 8-11 below.
Figure 8-11: The Flash Update Window
• Press [F2] (Cancel) to return to Operate Mode without
erasing the program.
• Press [F3] (OK) to confirm that you wish to erase the
program.
4. The meter asks for confirmation. Again, press
[F2] (Cancel) to
return to Operate Mode or
[F3] (OK) to continue with the
update. After the PM880 reboots, the screen appears similar to
Figure 8-12 below.
Figure 8-12: Flash Reloading Window
Update Flash
OK
--WARNING--
This will erase the
instrumentation coding.
Choose ‘Cancel’ to exit or ‘OK’
to continue.
Cancel
Panametrics PCI Loader v3.0 2/26/02
[HW Rev3+]
Reload Flash via Infrared (Yes/No)?
Backup Battery: OK
Firmware CRC: Valid
IrOBEX No
IrCOMM
To Next Page
Loading...
Need help?
General
