To Next Page

To Previous Page

GE Reason Switches

Chapter 5 – Interfaces

REASON SWITCHES-TM-EN-3

119

show ip interface ?

It will be displayed all of the options allowed at the interface menu. “brief” will be the

only choice. Then, type:

show ip interface brief

The command above is the full command to view all IP interfaces configured at the

equipment. After typing it at the command line, press enter.

This online help can be used anytime when configuring the equipment through this

interface. If necessary, the user can access it as a guide to perform the configuration

through SSH protocol interface.

6.3 Telnet

Telnet configuration interface can be used through Ethernet (electrical or optical)

connections. To use this protocol, it is necessary to know the IP of the equipment to

be accessed. If used, this interface requires a computer with Telnet-aware software

to communicate with Reason Switches.

Allowed commands at the main menu are:

 clear reset functions;

 configure enter configuration mode;

 copy copy from source to destination;

 delete delete one file in flash: file system;

 dir directory of all files in flash: file system;

 disable turn off privileged commands;

 do to run exec commands in configuration mode;

 dot1x IEEE standard for port-based access control;

 enable turn on privileged commands;

 erps Ethernet Ring Protection switching;

 exit exit from EXEC mode;

 failsafe configure failsafe relay;

 firmware firmware upgrade or swap;

GE S2020 User Manual

Questions and Answers: