Figure 78: Main menu at the Telnet interface
If necessary, Reason Switches have an online help at this interface. Thus, when
typing a command plus “?” it will be displayed all allowed subcommands of a given
menu. For example, if it is necessary to view all IP interfaces configured at the
equipment, type first:
show ?
It will be displayed all of the options allowed at the show menu. “IP” menu will be
there. Then, type:
show ip ?
It will be displayed all of the options allowed at the IP menu. “interface” will be there.
Then, type:
show ip interface ?
It will be displayed all of the options allowed at the interface menu. “brief” will be the
only choice. Then, type:
show ip interface brief
The command above is the full command to view all IP interfaces configured at the
equipment. After typing it at the command line, press enter.
This online help can be used anytime when configuring the equipment through this
interface. Thus, if necessary, the user can access it as a guide to perform its
configuration at SSH protocol interface.
To Next Page
Loading...
Need help?
General
