XIV
7.1 Entering Miscellaneous Functions M and STOP ..... 176
Fundamentals ..... 176
7.2 Miscellaneous Functions for Program Run Control, Spindle and Coolant ..... 177
Overview ..... 177
7.3 Miscellaneous Functions for Coordinate Data ..... 178
Programming machine-referenced coordinates: M91/M92 ..... 178
Activating the most recently entered datum: M104 ..... 180
Moving to position in an non-tilted coordinate system with a tilted working plane: M130 ..... 180
7.4 Miscellaneous Functions for Contouring Behavior ..... 181
Smoothing corners: M90 ..... 181
Insert rounding arc between straight lines: M112 ..... 182
Machining small contour steps: M97 ..... 182
Machining open contours: M98 ..... 183
Feed rate factor for plunging movements: M103 ..... 183
Feed rate in millimeters per spindle revolution: M136 ..... 184
Feed rate at circular arcs: M109/M110/M111 ..... 185
Calculating the radius-compensated path in advance (LOOK AHEAD): M120 ..... 185
Superimposing handwheel positioning during program run: M118 ..... 187
Retraction from the contour in the tool-axis direction: M140 ..... 188
Suppressing touch probe monitoring: M141 ..... 189
Delete modal program information: M142 ..... 190
Delete basic rotation: M143 ..... 190
7.5 Miscellaneous Functions for Rotary Axes ..... 191
Feed rate in mm/min on rotary axes A, B, C: M116 ..... 191
Shorter-path traverse of rotary axes: M126 ..... 191
Reducing display of a rotary axis to a value less than 360°: M94 ..... 192
Automatic compensation of machine geometry when working with tilted axes: M114 ..... 193
Maintaining the position of the tool tip when positioning with tilted axes (TCPM*): M128 ..... 194
Exact stop at corners with nontangential transitions: M134 ..... 196
Selecting tilting axes: M138 ..... 196
Compensating the machine’s kinematic configuration for ACTUAL/NOMINAL
positions at end of block: M144 ..... 197
7.6 Miscellaneous Functions for Laser Cutting Machines ..... 198
Principle ..... 198
Output the programmed voltage directly: M200 ..... 198
Output voltage as a function of distance: M201 ..... 198
Output voltage as a function of speed: M202 ..... 199
Output voltage as a function of time (time-dependent ramp): M203 ..... 199
Output voltage as a function of time (time-dependent pulse): M204 ..... 199
7 Programming: Miscellaneous functions ..... 175
To Next Page
Loading...
Need help?
General
