82 4 Programming: Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.12 Pallet Management
Selecting a pallet table
U Call the file manager in the Programming and Editing or Program
Run mode: Press the PGM MGT key.
U Display all type .P files: Press the soft keys SELECT TYPE and
SHOW .P.
U Select a pallet table with the arrow keys, or enter a new file name
to create a new table.
U Confirm your entry with the ENT key.
To leave the pallet file:
U To call the file manager, press the PGM MGT soft key.
U To select a different type of file, press the SELECT TYPE soft key
and the soft key for the desired file type, for example SHOW.H.
U Select the desired file.
Executing the pallet file
U Select the file manager in the operating mode Program Run, Full
Sequence or Program Run, Single Block: Press the PGM MGT key.
U Display all type .P files: Press the soft keys SELECT TYPE and
SHOW .P.
U Select pallet table with the arrow keys and confirm with ENT.
U To execute pallet table: Press the NC Start button. The TNC
executes the pallets as set in Machine Parameter 7683.
In machine parameter 7683, set whether the pallet table
is to be executed blockwise or continuously (see “General
User Parameters” on page 448).
To Next Page
Loading...
Need help?
General
