368 10 Programming: Q Parameters
10.8 Additional Functions
FN14: ERROR: Displaying error messages
With the function FN14: ERROR you can call messages under
program control. The messages were preprogrammed by the machine
tool builder or by HEIDENHAIN. The program must then be restarted.
The error number are listed in the table below.
Example NC block
The TNC is to display the text stored under error number 254:
Error number Text
1000 Spindle ?
1001 Tool axis is missing
1002 Slot width too large
1003 Tool radius too large
1004 Range exceeded
1005 Start position incorrect
1006 ROTATION not permitted
1007 SCALING FACTOR not permitted
1008 MIRRORING not permitted
1009 Datum shift not permitted
1010 Feed rate is missing
1011 Entry value incorrect
1012 Wrong sign programmed
1013 Entered angle not permitted
1014 Touch point inaccessible
1015 Too many points
1016 Contradictory entry
1017 CYCL incomplete
1018 Plane wrongly defined
1019 Wrong axis programmed
1020 Wrong RPM
1021 Radius comp. undefined
1022 Rounding-off undefined
1023 Rounding radius too large
1024 Program start undefined
1025 Excessive subprogramming
1026 Angle reference missing
1027 No fixed cycle defined
1028 Slot width too small
1029 Pocket too small
1030 Q202 not defined
1031 Q205 not defined
1032 Enter Q218 greater than Q219
1033 CYCL 210 not permitted
1034 CYCL 211 not permitted
1035 Q220 too large
1036 Enter Q222 greater than Q223
1037 Q244 must be greater than 0
1038 Q245 must not equal Q246
1039 Angle range must be < 360°
1040 Enter Q223 greater than Q222
1041 Q214: 0 not permitted
Range of error numbers Standard dialog text
0 ... 299 FN 14: Error code 0 .... 299
300 ... 999 Machine-dependent dialog
1000 ... 1099 Internal error messages (see table
at right)
180 FN14: ERROR = 254
To Next Page
Loading...
Need help?
General
