424 12 MOD Functions
12.4 Setting the Data Interfaces
Software for data transfer
For transfer of files to and from the TNC, we recommend using one
the HEIDENHAIN TNCremo data transfer software products for data
transfer, such as TNCremo or TNCremoNT. With TNCremo/
TNCremoNT, data transfer is possible with all HEIDENHAIN controls
via serial interface.
System requirements for TNCremo:
n AT personal computer or compatible system
n Operating system MS-DOS/PC-DOS 3.00 or later, Windows 3.1,
Windows for Workgroups 3.11, Windows NT 3.51, OS/2
n 640 KB working memory
n 1 MB free memory space on your hard disk
n One free serial interface
n A Microsoft-compatible mouse (for ease of operation, not essential)
System requirements for TNCremoNT:
n PC with 486 processor or higher
n Operating system Windows 95, Windows 98, Windows NT 4.0
n 16 MB working memory
n 5 MB free memory space on your hard disk
n One free serial interface or connection to the TCP/IP network on
TNCs with Ethernet card
Installation under Windows
U Start the SETUP.EXE installation program in the file manager
(Explorer).
U Follow the instructions of the setup program.
Starting TNCremo under Windows 3.1, 3.11 and NT 3.51
Windows 3.1, 3.11, NT 3.51:
U Double-click on the icon in the program group HEIDENHAIN
Applications.
When you start TNCremo for the first time, you will be asked for the
type of control you have connected, the interface (COM1 or COM2)
and the data transfer speed. Enter the necessary information.
Starting TNCremoNT under Windows 95, Windows 98 and NT 4.0
U Click on <Start>, <Programs>, <HEIDENHAIN Applications>,
<TNCremoNT>
When you start TNCremoNT for the first time, TNCremoNT
automatically tries to set up a connection with the TNC.
Please contact your HEIDENHAIN agent if you would like
to receive the TNCremo or TNCremoNT data transfer
software for a nominal fee.
To Next Page
Loading...
Need help?
General
