414 11 Test run and Program Run
11.5 Automatic Program Start
11.5 Automatic Program Start
Function
In a Program Run operating mode, you can use the soft key
AUTOSTART (see figure at upper right) to define a specific time at
which the program that is currently active in this operating mode is to
be started:
U Show the window for entering the starting time (see
figure at center right).
U Time (h:min:sec): Time of day at which the program
is to be started
U Date (DD.MM.YYYY): Date at which the program is to
be started
U To activate the start, set the AUTOSTART soft key to
ON.
The TNC must be specially prepared by the machine tool
builder for use of the automatic program start function.
Refer to your machine manual.
To Next Page
Loading...
Need help?
General
